Claudine Carpenter TV Stand November 26th, 2018 - 06:44:27
The TV corner wall mounts for 23 to 55-inch displays for this install. You will need a power drill, a 3/16 inch or four point five-millimeter drill bit a metric, socket wrench blue tape. A tape measure, a Phillips, screwdriver, medium or large, a flat head, screwdriver, medium or large, a pencil, a level, and a stud finder is very helpful, open the box and inspect all the products. Ensuring that everything is there make sure to find the instructions all right. You guys once you've determined approximately where your corner mount is going to go, be sure to check the wall for low voltage, wires water pipes and electrical conduit.
That would not be sexy in order to find where your stud in the wall is a stud. Finder can be very helpful. You simply place it on the wall, push the button and it helps you to figure out where the stud is in the wall. Once you've determined where the studs are in your wall go ahead and hold up the rack to the approximate location and mark where the screw holes are. I've did this on this wall and this wall, finding a stud we're done now we're going to drill the pilot holes. We've got our drill bit here.
It also comes with this small wrench that you can use now you're going to need six for this. There are more in case you're putting it into masonry or brick, but we're not going to do that installation today for more information, you can just read the leaflet. That's in the box, all right! You guys it's time to get this up on the wall. I find it easiest. You can either have a friend help you, but if you don't have a friend, you can still do it by yourself.