John Frederick TV Stand September 21st, 2018 - 01:23:46
The fireplace TV stand would be underneath to be recessed and all this stuff will be gone, the piece of the air stone and based on the instructions were supposed to use a Hacksaw, if you've marked it and you start you know, cutting it and my opinion tastes entire too long. So hurting myself was the biggest concern here without cut-up ton of these pieces. So if I have to get a new blade, when I'm done with this, I'm okay, as long as you can see, I measure it at about you want to get it right on there, so I move it over just a tad bit yeah.
That would be a perfect cut there and then I'm going to install it as far as the funny what happened after you've already measured to make sure it's big there's only us. You can see that come over here once you see that you made the cut the right size and you can give it in there and you just simply take it off put a little plenty on the bottom now. I was really kicking this stuff on yesterday, but you really don't take all that and then you put a decent-enough on the back side of it and always want to put some on every side. That's going to be touching something. Obviously, on this side, I'm going to have some of the funny or some of the stone touching the other piece, but on this side, I'm not.
Have it touching anything but the fireplace. So I really need any of that putty there, but ya, see if you just get it on there, a nice amount. I mean it's a some of this a come off anyway. You're a have to wipe it down, make sure you wipe it down right away with a wet rag if you get any extra on there. But that looks about right to me.
You know put a little bit on there spread it across and then you fit that piece right on in there. Yes, like that, put a little pressure on there, make it firm and then watch your ass, that's off and that's it. At this stage, I gotta do title across here and it's a be very careful because if you put it all the way across this a slide down, so I'm trying to go, you know fairly slow. I'm a put a couple pieces up and then I'm a wait a couple hours and we'll let this whole course roll sit.
I'm a wait a couple hours and then I'm a comeback and you know try to put another roll on it and then I'll wait a couple hours and or maybe not even that long just enough for it. Ain't a move, but I'm trying not to use these huge blocks, but I wanted it to be a little bit different than what I have over there. I'm probably a go hole. You know thin blocks for one row and then change it up going up. Just sitting back admire and my work all of a sudden. I noticed that that edge is not straight.